Development Tool Accessories (247 artikelen)

Grove - Universal 4 Pin connector is the white 4-pin buckled connector used on Stem, Twigs and the Grove cables, the pin spacing is 2mm. There are 10 connectors per bag, Users can use them to DIY.

Compared with the Electronic Brick system, the Grove System uses only 1 type of cable, (the Electronic Brick system uses 4). These cables are compatible with all modules included in the Grove syste...

The Universal 4 Pin Buckled Cable is made for the Grove System to connect all of the Twigs to the Stem - Basic Shield or to other Grove compatible boards for quick prototyping. As a lot of users as...

Grove - Universal 4 Pin connector 90° is the white 4-pin buckled connector used on Stem, Twigs and the Grove cables, the pin spacing is 2mm. There are 10 connectors per bag, Users can use them to DIY.

The Universal 4 Pin Buckled Cable is made for the Grove System to connect all of the Twigs to the Stem - Basic Shield or to other Twig compatible boards for quick prototyping. As a lot of users ask...

Grove is a convenient plug-and-play system with specialized interface, but that doesnt mean it couldnt be used in open ecosystem like breadboard. With this special designed conversion cables, you c...

Accessory Type = Development Kit For Use With = STM32WLE5JC Module

J-Link 19-Pin Cortex-M Adapter. The J-Link 19-pin Cortex-M Adapter allows JTAG, SWD and SWO connections between J-Link and ARM Cortex-M based target hardware systems. Supported Probes. • J-Link BAS...

J-Link RX Adapter. The J-Link RX Adapter maps from the J-Link 20-pin 0.1in connector to the 14-pin 0.1in Renesas connector and allows JTAG + FINE connections to Renesas RX family microcontroller de...

J-Link 9-Pin Cortex-M Adapter. The J-Link 9-pin Cortex-M Adapter allows JTAG, SWD and SWO connections between J-Link and ARM Cortex-M based target hardware systems. Supported Probes. • J-Link BASE ...

The SEGGER J-Link 14-Pin TI Adapter converts the 20-pin, 0.1 inch standard connector to a 14-pin, 0.1 inch Texas Instruments connector.Includes a 14-pin TI cable

J-Link 10-Pin Needle Adapter. The J-Link 10-pin Needle Adapter has been designed to connect a J-Link Probe to a PCB which does not have a mating connector or programming header. Compatible Probes. ...

The SEGGER J-Link TI-CTI-20 Adapter has been designed to connect from the standard J-Link/J-Trace/Flasher 20-pin 0.1″ target connector to TI CTI-20 connector.Adapter permits the connection of the J...

The SEGGER Adapter for PPC targets with 14-pin 0.1″ mating JTAG connectors.Includes a 14-pin ribbon cable

The SEGGER J-Link Mictor 38 Adapter connects the standard 20-pin 0.1″ J-Link interface to the 38-pin Mictor interface. The pinout follows the single target connector pinout specification as defined...