arduino  (7.835 artikelen gevonden)

Colour 7 click is a very accurate Colour sensing Click board™ which features the TCS3472 Colour light to digital converter with IR filter, from ams. It contains a 3x4 matrix of photosensitive eleme...

Vacuum click is an accurate vacuum pressure sensing click board™, capable of measuring absolute pressure values down to -115kPa. This click board™ utilizes the MPXV6115V, a very accurate vacuum pre...

Power Management Function = Electronic Fuse For Use With = mikroBUS socket Kit Classification = Add On Board Featured Device = NIS6150 Kit Name = eFuse 3 Click

The MIKROE is a low power 9 axis highly integrated sensor which gives precise acceleration with geomagnetic measurement in each structural direction.1.7 to 3.6V of operating voltage Power saving an...

Key features Ultra-Small package LGA package (12 pins), footprint 2mm x 2mm, height 0.95mm Digital interface SPI (4-wire, 3-wire), I²C, 2 interrupt pins VDDIO voltage range: 1.2V to 3.6V Programmab...

DIGI POT 4 click is a digitally controlled dual potentiometer, with the resistance of 10KΩ. It has a 10bit resolution which allows for a very smooth linear wiper positioning through 1024 steps. Dig...

EMG click measures the electrical activity produced by the skeletal muscles. It carries MCP609 operational amplifier and MAX6106 micropower voltage reference. EMG click is designed to run on a 5V p...

PT100 3-wire temperature probe is a type of RTD platinum probe used to measure temperatures up to 250°C. This type of probe can be used with RTD click.RTD sensors are basically thermosensitive resi...

Ultra-Small X2QFN Package:2 mm x 1.5 mm x 0.4 mm 12-Bit Noise-Free Resolution Wide Supply Range: 2.0 V to 5.5 V Low Current Consumption: 150 μA (Continuous-Conversion Mode) Programmable Data Rate:1...

Kit Name = DIGIPOT 2

The MikroElektronikas EnOcean 4 Click carries a ultra-low power TCM515U transceiver gateway module which operates at 902MHz radio band, perfectly suited for the realization of transceiver gateways,...

DHT22 2 click is used for measuring the environmental temperature and relative humidity. It uses the CM2322 sensor, with very accurate thermal and humidity measuring capabilities. It can use either...

Uses the Si7034, a digital humidity and temperature sensor IC with I2C inter- face, from Silicon Labs.

Classification = Add On Board Kit Classification = Add On Board For Use With = mikroBUS socket Featured Device = MT8870D, PCA9536 Kit Name = DTMF Decoder ClickMHz

Environment click measures temperature, relative humidity, pressure and VOC (Volatile Organic compounds gases). The click carries the BME680 environmental sensor from Bosch. Environment click is de...