development tool accessories  (1.001 artikelen gevonden)

The SEGGER J-Link TI-CTI-20 Adapter has been designed to connect from the standard J-Link/J-Trace/Flasher 20-pin 0.1″ target connector to TI CTI-20 connector.Adapter permits the connection of the J...

J-Link 10-Pin Needle Adapter. The J-Link 10-pin Needle Adapter has been designed to connect a J-Link Probe to a PCB which does not have a mating connector or programming header. Compatible Probes. ...

The SEGGER Adapter for PPC targets with 14-pin 0.1″ mating JTAG connectors.Includes a 14-pin ribbon cable

The SEGGER J-Link Mictor 38 Adapter connects the standard 20-pin 0.1″ J-Link interface to the 38-pin Mictor interface. The pinout follows the single target connector pinout specification as defined...

The SEGGER J-Link 2mm Adapter converts the 20-pin, 0.1 inch pitch standard J-Link connector to a 20-pin, 2mm pitch connector.The J-Link 2mm Adapter is a 1:1 adapter

The SEGGER J-Link RX FINE Adapter converts the 20-pin, 0.1 inch standard connector to a 14-pin, 0.1 inch RX FINE connector. Includes the necessary cable.Package includes: .1″ 14-pin ribbon cable (1...

The SEGGER J-Link SiLabs C2 Adapter converts the 20-pin, 0.1 inch pitch standard J-Link connector to a 10-pin, 0.1 inch pitch SiLabs C2 connector.Includes 10 pin ribbon cable

J-Link ARM7/9/11 14-Pin Adapter. The J-Link 14-Pin Adapter allows J-Link to work with ARM7/9/11 target processors. It is not needed with most new evaluation boards. Supported Probes. • J-Link BASE ...

The SEGGER J-Link 6-pin Needle Adapter has been designed to connect J-Link to a PCB which does not come with a mating connector or programming header.No additional connector required on your PCB Ve...

The SEGGER Intel FPGA Adapter (formerly J-Link Altera Adapter) connects to the 10-pin 100-mil Intel FPGA JTAG connector providing debug access to FPGA based MCU cores like the dual-core ARM Cortex-...

SEGGER Microcontroller AdapterThe SEGGER Microcontroller adapter is J-Trace MICTOR 38 adapter that connects to the 38-pin MICTOR connector. It connects the GND, JTAG and some trace pins to their co...

Accessory Type = NFC Tag

The SEGGER SiFive-ARTY Adapter allows debug connections between J-Link and the ARTY board running SiFive RISC-V core bitstreams.The ARTY board provides several identical headers where the JD header...

The SEGGER Adapts from the standard J-Link 20-pin 0.1″ target connector to Xilinx 14-pin 2 mm connector (comp. Platform Cable USB II).Package includes: 14-pin 2mm ribbon cable

Accessory Type = Adapter Board For Use With = DIL24 Socket