monk makes  (17 artikelen gevonden)

The MonkMakes Speaker for micro:bit is a neat little amplified speaker that connects to your micro:bit using alligator clips. Despite its small size, this speaker is pretty loud.Amplified output LE...

The MonkMakes Servo kit for micro:bit makes it easy to connect up three servomotors from your micro:bit. Not only that, the kit also comes with three servomotors a battery box and a booklet showing...

The MonkMakes 7-segment for micro:bit is a four digit 7-segment display for micro:bit. You can use it to display numbers, but it can also display letters and other characters, albeit with the limit...

The MonkMakes, It can be tricky to work out which pin is which when the Raspberry Pi Pico is attached to solderless breadboard. The MonkMakes Breadboard for Pico solves this problem by labelling th...

The MonkMakes Charger Kit for micro:bit is a LiPo battery and charger board that charges automatically while you use your micro:bit. This neat solution to your micro:bit’s power needs comes with an...

The MonkMakes GPIO Adapter for Pi 400 is the state of the art development board add-on for developing projects based on Raspberry Pi. The add-on makes the pins of the adapter more accessible to the...

The MonkMakes Alligator Leads designed for use with the BBC micro:bit to use the 4mm connection holes.

The MonkMakes, This low-cost simple to use electronics kit will teach you electronics and coding with your Raspberry Pi Pico.It is low cost

The MonkMakes Connector for micro: bit is the state of the art development board add-on for developing projects based on I2C or SPI communication based modules, etc. The output of the add-on is sti...

The MonkMakes Slider for micro: bit is the state of the art development board add-on for developing projects which interact with the micro: bit using the sliding mechanism. It uses a 10K-OHM potent...

The MonkMakes RGB LED for micro:bit provides a colourful add-on to your micro:bit. Connect it to your micro:bit with alligator clips or nuts and bolts and then use the three outputs of your micro:b...

The MonkMakes CO2 Sensor board for micro:bit is designed for use with the Lets Talk Science Living Space Project, provides a CO2, temperature and Relative Humidity measurements to a BBC micro:bit.

The MonkMakes electronic Starter Kit for micro:bit contains everything needed to start learning about connecting electronics to the micro:bit in an accessible and easy manner. Everything is connect...

For Use With Raspberry Pi Accessory Type LED Array and Push Button Switches

For Use With Raspberry Pi Accessory Type Servo Kit