segger  (103 artikelen gevonden)

The SEGGER Intel FPGA Adapter (formerly J-Link Altera Adapter) connects to the 10-pin 100-mil Intel FPGA JTAG connector providing debug access to FPGA based MCU cores like the dual-core ARM Cortex-...

SEGGER Microcontroller AdapterThe SEGGER Microcontroller adapter is J-Trace MICTOR 38 adapter that connects to the 38-pin MICTOR connector. It connects the GND, JTAG and some trace pins to their co...

J-Link Target Supply Adapter. The J-Link Target Supply Adapter provides an adjustable power supply to a target board. Compatible Probes. Segger J-Link BASE Emulator ( ; 131-1319) 131-1319) , J-Link...

The SEGGER Adapts from the standard J-Link 20-pin 0.1″ target connector to Xilinx 14-pin 2 mm connector (comp. Platform Cable USB II).Package includes: 14-pin 2mm ribbon cable

The Flasher RL78 Adapter converts the standard J-Link 20-pin 0.1″ connector to the standard 14-pin E1 connector defined by Renesas. Please note that this adapter is usable only with the Flasher PRO...

J-Link ARM SWD Isolator Board. The J-Link SWD Isolator can be connected between a J-Link Probe and an ARM-board with a 20-pin debug connector to provide electrical isolation. This is essential when...

The SEGGER Flasher STM8 Adapter converts the standard J-Link 20-pin 0.1″ connector to the SWIM connector and a standard 10-pin connector. In addition the target board can be power using the externa...

The SEGGER J-Link Microchip 2-Wire JTAG TDI Adapter allows debug connections between J-Link and target hardware which comes with Microchip IS208x series MCUs. It supports the Microchip 6-pin single...

The SEGGER SiFive-ARTY Adapter allows debug connections between J-Link and the ARTY board running SiFive RISC-V core bitstreams.The ARTY board provides several identical headers where the JD header...

SEGGER Microcontroller J-TraceThe SEGGER Microcontroller KG J-Trace is an isolator. It can be connected between a J-Trace Pro V2 or any ARM-board that uses the standard 19-pin Cortex-M connector to...

J-Link ARM7/9/11 14-Pin Adapter. The J-Link 14-Pin Adapter allows J-Link to work with ARM7/9/11 target processors. It is not needed with most new evaluation boards. Supported Probes. • J-Link BASE ...

Reduced form factor ARM/Cortex Debug Probe, Microchip PIC32 Debug Probe, Renesas RX Debug Probe, and SiLabs EFM8 / C8051 Debug Probe. Includes a USB cable, and a 20-pin, 0.1″ ribbon cable. Addition...

20-pin 0.1in target ribbon cable, USB cable. Flasher Portable PLUS Programmer. Flasher Portable PLUS has been designed to fill the need for a portable, battery-operated production-grade Flash memor...

The SEGGER NAND-Flash EVAL evaluation board is an easy to use and cost effective testing tool designed to permit the evaluation of the features and the performance of the emFile NAND driver with va...

J-Link USB Isolator Board. The J-Link USB Isolator may be connected in a J-Link Probe to Host PC USB link to provide electrical isolation. This is essential when development tools are not connected...