Digilent 410-308 Programming Module for use with FPGA Devices

This module is not needed for Digilent Xilinx FPGA boards as they have this functionality built-in. JTAG-SMT2 SMT Programming Module. The JTAG-SMT2 surface-mount programming module allows high-speed programming of Xilinx FPGA devices from a host PC. Users can solder the module directly onto a target board like any other component. Note: The JTAG-SMT2-NC part (RS ; 134-6473 134-6473 ) does not have a USB connector fitted. Features. Compatible with all Xilinx tools Compatible with IEEE 1149.7-2009 Class T0 - Class T4 (includes 2-Wire JTAG) On-board ADP123AUJZ 300mA voltage regulator Separate Vref drives JTAG/SPI signal voltages Vref can be any voltage between +1.8V and +5V USB 2.0 HS port drives JTAG/SPI bus at up to 30Mbit/sec JTAG/SPI frequency settable by user PC connector: MicroUSB ( JTAG-SMT2 only) GPIO pin allows processor reset of Xilinx Zynq platform SPI programming modes 0/2 up to 30Mbit/sec, modes 1/3 up to 2Mbit/sec Fully supported by Digilent's Adept software and Adept SDK Board dimensions: 22.75 x 21.5mm. RS Product Codes. 134-6434 134-6434 JTAG-SMT2 SMT Module 134-6473 134-6473 JTAG-SMT2-NC SMT Module (without USB connector)