Nexperia PCMF3USB30Z, Dual-Element ESD Protection Diode, 15-Pin WLCSP

Common Mode filter for USB ports, No room for compromise, The most common camera and display interface used now for portable devices is the differential MIPI interface running at RF frequencies. To allow operation at typical GSM/3G/LTE frequencies, a strong common-mode suppression over all bands and higher harmonics is needed. At the same time, a wide differential passband is needed to keep signal integrity. Since ESD can enter through gaps in the portable device, strong ESD protection is needed to avoid damage of the electronics or re-setting the system due to ESD strikesStrong common-mode suppression > 14 dB in the range between 500 MHz and > 8 GHz Wide passband > 2 GHz, ensuring signal integrity for all MIPI frequencies ESD ruggedness > 15 kV contact, far exceeding IEC 61000-4-2 (8 kV contact) Deep snap-back for optimized SoC protection against ESD strikes Very thin package (0.5 mm max package height) All LVDS signals needing a passband up to 2 GHz