STMicroelectronics Nucleo Pack MCU Development Kit P-NUCLEO-IOM01M1

STEVAL-IOM001V1 IO-Link master PHY based on L6360 Interrupt diagnostics pin I²C and UART interface SPI (slave) interface 65 mA selectable (3.3 or 5.0 V) linear regulator CQ (push-pull) and L+ (high side) switches IQ additional IEC61131-2 type 1 digital input L+ and CQ overload and overheating protections with non-dissipative cut-off function QFN-26L (3.5x5x1 mm) package Operating voltage range from 18 to 32.5 V Additional high side switch for L+ heavy loads LEDs for status and diagnostics Ground and VCC wire break protections Equipped with ST morpho connectors 32-bit Micro-controller based on ARM®Cortex®-M4 core (180 MHz max.) with 512-Kbyte Flash memory and 128 (+4) Kbyte RAM Two types of extension resources: Arduino™ UNO Revision 3 connectivity and ST morpho extension pin headers for full access to all STM32 I/Os Mbed-enabled On-board ST-LINK/V2-1 debugger/programmer with SWD connector: selection-mode switch to use the kit as a standalone ST-LINK/V2-1 Two push-buttons: USER and RESET