ABB Safety Controller

TUV, FS, CSA. The IDFIX device ( ; 733-4824 733-4824 ) is connected between the input terminals ID and 0V (also note that the IDFIX device is not required when using a single Pluto, however the absense of an IDFIX requires to be stated when programming the Pluto device.). Pluto Safety PLC, Base Unit. Pluto from ABB is an "All-Master" safety PLC concept, which simplifies the design of safety systems and achieves the highest safety category 4 according to EN 954-1. All Pluto's are Master units and can see the other Pluto's inputs, outputs and global memories. This enables the Pluto to evaluate the information from the other Pluto's and then take decisions concerning its own safety devices. The Gateway units are available for several different bus systems, i.e. Profibus ( ; 733-4836 733-4836 ), CanOpen ( ; 733-4830 733-4830 ), Devicenet ( ; 733-4849 733-4849 ) and Ethernet ( ; 733-4842 733-4842 ). Of Pluto's inputs (the smallest unit has 16 I/O), thus can be configured as either inputs or outputs. In the Pluto family by ABB most modules have dual safety outputs - potential free or PNP types. In a two-wire bus system up to 32 Pluto units can be safely connected and communicate with a superior system via a Gateway or HMI displays. Therefore within a maximum extended system 1472 I/O's can be connected. Also all input components may be connected in series for even more complexity and optimisation. Simple and easy programming facilities Easy to configure and install Up to 640 I/O's Multiple Plutos can be connected on a bus (via using the IDFIX identifier) and then further interfaced with external networks by using a Gateway, typical example RS stock number ( ; 733-4842 733-4842 ) High safety level Free software available Programming over the bus 35 mm DIN rail mounting The IDFIX ( ; 733-4824 733-4824 ) is an identification circuit which allows multiple Plutos to be identified when connected on a bus system. This module is available to distribute a PLC program within a network of Pluto devices. Tina adapters such as ( ; 733-2477 733-2477 ) can be used to connect external safety monitoring equipment