development tools & single board computers  (5.496 artikelen gevonden)

Classification = Relay Module Kit Classification = Module Featured Device = Relay Control Card Kit Name = USBB-RELAY08

The SEGGER J-Link Mictor 38 Adapter connects the standard 20-pin 0.1″ J-Link interface to the 38-pin Mictor interface. The pinout follows the single target connector pinout specification as defined...

The SEGGER Intel FPGA Adapter (formerly J-Link Altera Adapter) connects to the 10-pin 100-mil Intel FPGA JTAG connector providing debug access to FPGA based MCU cores like the dual-core ARM Cortex-...

Power, Motor & Robotics Development Tools

Classification = Relay Module

The SEGGER J-Link Measurement+Patch Adapter provides test points for all debug signals to allow easy access for test probes. It has a standard 20-pin 0.1″ socket towards the J-Link debug probe and ...

The SEGGER Adapts from the standard J-Link 20-pin 0.1″ target connector to Xilinx 14-pin 2 mm connector (comp. Platform Cable USB II).Package includes: 14-pin 2mm ribbon cable

Grove - I2C FM Receiver is a wideband FM receiver module, this module is based on RDA5807M. The RDA5807M series are the latest generation single-chip broadcast FM stereo radio tuner with fully inte...

The SEGGER Adapter for PPC targets with 14-pin 0.1″ mating JTAG connectors.Includes a 14-pin ribbon cable

J-Link Target Supply Adapter. The J-Link Target Supply Adapter provides an adjustable power supply to a target board. Compatible Probes. Segger J-Link BASE Emulator ( ; 131-1319) 131-1319) , J-Link...

J-Link USB Isolator Board. The J-Link USB Isolator may be connected in a J-Link Probe to Host PC USB link to provide electrical isolation. This is essential when development tools are not connected...

Power, Motor & Robotics Development Tools

The SEGGER J-Link Signal Smoothing Adapter can be inserted between the J-Link debug probe and the debug target to overcome signal integrity issues. Depending on target load capacitance, signals mig...

The SEGGER Flasher STM8 Adapter converts the standard J-Link 20-pin 0.1″ connector to the SWIM connector and a standard 10-pin connector. In addition the target board can be power using the externa...

Microcontroller Development Tools