SEGGER Flasher Portable PLUS, Development Kit for FLASH microcontrollers

20-pin 0.1in target ribbon cable, USB cable. Flasher Portable PLUS Programmer. Flasher Portable PLUS has been designed to fill the need for a portable, battery-operated production-grade Flash memory programmer used for in-field firmware updates. Initial setup/preparation for stand-alone mode operation is done via the J-Flash software. It supports storage of multiple configurations/image files, so one unit can be used for different targets. The Flasher Portable PLUS represents a significant upgrade to its predecessor, the Flasher Portable. Supported Processors. • ARM 7/9/11. • ARM Cortex-A5/A7/A8/A9/A12/A15/A17. • ARM Cortex-M0/M0+/M1/M3/M4/M7. • ARM Cortex-R4/R5. • Freescale e200z0 (PowerPC). • Renesas RX610/RX621/RX62G/RX62N/RX62T/RX630/RX631/RX63N/RX63T. Features. • Stand-alone in-circuit-programmer. • Powered by 680mAh rechargeable Li-Ion battery or USB. • Up to 10 hours programming with one battery charge. • Stores up to eight configurations/data files. • 1.8in LCD panel for display of programming status. • Pushbutton selects between stored images/configurations. • 128MB memory for configuration and data file storage. • Supports internal and external Flash devices. • Data files can be updated via mass storage or via J-Flash. • Host interface: USB 2.0. • Target interfaces: 20-pin JTAG/SWD/FINE/SPD. • Programming speed typically between 30KB/sec and 1MB/sec. • Max programming speed depends on target hardware and max programming speed of the Flash memory. • Authorized Flashing limits number of programming cycles and protects against non-authorized access. • Dimensions: 126 x 70 x 28mm. • Free software updates, 1 year of support