Digilent Arty Z7-20 APSoC Zynq-7000 Development Board

Arty Z7 Zynq-7000 Development Board. The Arty Z7-20 is a development platform designed around the Xilinx Zynq-7000™ All Programmable System-on-Chip (AP SoC). The Zynq-7000 architecture integrates a dual-core, 650MHz ARM Cortex-A9 processor with Artix-7 series FPGA logic. This pairing surrounds a powerful processor with a unique set of software defined peripherals and controllers. The Vivado, Petalinux, and SDSoC toolsets each provide a path between defining your custom peripheral set and bringing its functionality up to a Linux OS or 'bare-metal' program running on the processor. Xilinx Zynq-7000 (XC7Z020-1CLG400C). Processor: 650MHz dual ARM Cortex-A9 core Look-up Tables (LUTs): 53200 Flip-flops: 106400 Block RAM: 630KB Clock Management Tiles: 4 Available Shield I/O: 49 DDR3 memory controller with 8 x DMA channels and 4 x AXI3 Slave ports High-bandwidth peripheral controllers: 1G Ethernet, USB 2.0, SDIO Low-bandwidth peripheral controller: SPI, UART, CAN, I²C Programmable from JTAG, Quad-SPI Flash or microSD card Programmable logic equivalent to Artix-7 FPGA Memory. Board Memory and Power. On-board IS43TR16256A-125KBL 512MB DDR3 SDRAM with 16-bit bus @ 1050Mbps On-board S25FL128S 16MB Quad-SPI Flash with 48-bit unique EUI-48/64™ compatible identifier microSD card slot Powered from USB or +7V to +15Vdc via barrel jack. System Connectivity. 10/100/1000 Ethernet via RJ45 connector USB-UART Bridge via micro-B socket USB-JTAG Programming via micro-B socket USB OTG PHY (supports Host only) via USB-A socket. Audio and Video. HDMI sink port (input) HDMI source port (output) PWM driven mono audio output via 3.5mm jack socket. Switches and LEDs. Reset and Program pushbuttons 4 x User pushbuttons 2 x User slide-switches 4 x User LEDs 2 x User RGB LEDs. Expansion Connectors. chipKIT/Arduino R3 Shield headers 2 x Standard 12-pin Pmod™ connectors